FDS TBox-41 User Manual page 7

TBox-Radio
4.3 TBox-Radio Input (WINP/WIRC Pairing)
Each WINP/WIRC has a unique ID (serial number) that can be paired with a TBox-Radio input
(A-F).
Pairing can be performed on a TBox using the "TBox-Setup" application (no need to power
ON WIRC/WINP). Pairing can also be performed manually without any application. In this
case, both TBox-Radio and WINP/WIRC have to be powered and the following procedure
executed.
1) Make sure the TBox and the WINP/WIRC are both powered On.
2) On the TBox-Radio, enter the pairing mode by pressing the Setup button
until a long beep sounds and LED A flash yellow.
3) Now select the desired input (A, B, C or D) by performing a short press on the same
button.
4) Finally enter the pairing mode on the WINP/WIRC by pressing the Setup button
3 second.
When pairing is completed, LEDs A to D of the TBox flash yellow and both TBox and
WINP/WIRC resume normal operation.
To exit the pairing mode on either TBox or WINP/WIRC, just press the Setup button for 3
second until a long beep sound.
NOTE: In case an IOS or PC application is used to configure the radio inputs, do not use the
same WIRC/WINP serial number for more than one input.
February 2023 - Version EN 2.5
www.fdstiming.com
User manual
for 3 sec
for