Call Function - Midland XT50 PRO User Manual

To activate 1 of 38 different CTCSS/83 DCS tones in RX and TX
1. Turn on the radio.
2. Select the desired channel.
3. Press twice MENU until the Display shows oF (blinking on the right side).
4. By pushing the ▲/▼ controls the display will show CTCSS (blinking) or
5. DCS (blinking); press MENU to enter the CTCSS or DCS tones. Now
6. select the desired tone with the ▲/▼ keys.
To confirm the setting, press the PTT key or wait for approximately 5 se-
7.
conds.
Key tones
To deactivate the keypad beep, follow these steps:
1. Press MENU button, until "bP on" is displayed.
Use the ▲/▼ buttons until the display shows "bP of".
2.
Confirm by pushing the PTT or wait for 5 seconds.
3.
Now you won't hear any beep at the pressure of any button.

CALL function

XT50 PRO can send an audio signal to other users, by pressing CALL/ .
You can choose amongst 5 different call tones:
Push the MENU button 6 times, until the display shows "CA 1".
1.
2. By pushing ▲/▼ you will hear the 5 pre-set melodies.
3. Confirm by pressing the PTT key or wait for 5 seconds.
Now, each time your XT50 PRO sends out a tone call, it will beep with the
selected melody.
Choosing high or low transmission power (PMR band)
Batteries are drained more quickly during transmission. In order to extend the
battery life you can select the low power when transmitting over short distan-
ces. Procedure:
1. Press the MENU button for 3 times and Pr H will be displayed.
2. Select L using the scroll buttons ▲/▼.
3. Press PTT to confirm, or wait for 5 seconds.
If you want to transmit a longer distance repeat the above procedure to select
the high power. At step 2 select H. When the batteries are in good conditions,
high power is 500mW, whereas low power is 10mW.
A low battery level during transmission will reduce the performance of your
device.
8 | XT50 PRO user's manual