Table of Contents
Advertisement
Use terminal access doors for:
•
Inspection for secure connections (to tighten
hardware).
•
Inspection for corrosion.
•
Testing battery.
•
Jumping (if required).
•
Periodic charging.
DISCARD TERMINAL
KEPS NUT
PROTECTIVE CAPS
TERMINAL
ACCESS
DOOR
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
•
Remove adjustment knob and flat washer securing seat
to cardboard packing and set aside for assembly of seat
to tractor.
•
Pivot seat upward and remove from the cardboard
packing. Remove the cardboard packing and discard.
•
Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
•
Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor.
•
Pivot seat and pan forward and assemble adjustment
knob and flat washer loosely. Do not tighten.
•
Lower seat into operating position and sit on seat.
•
Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way down.
•
Get off seat without moving its adjusted position.
•
Raise seat and tighten adjustment knob securely.
SEAT PAN
FLAT WASHER
ADJUSTMENT
KNOB
ASSEMBLY
HEX BOLT
POSITIVE
(RED)CABLE
NEGATIVE
(BLACK)CABLE
FIG. 2
SEAT
SHOULDER
BOLT
FIG. 3
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
TO ROLL TRACTOR OFF SKID (See Opera-
tion section for location and function of con-
trols)
•
Press lift lever plunger and raise attachment lift lever to
its highest position.
•
Release parking brake by depressing brake pedal.
•
Place freewheel control in disengaged position to disen-
gage transmission (See "TO TRANSPORT" in the
Operation section of this manual).
•
Roll tractor forward off skid.
•
Remove banding holding the deflector shield up against
tractor.
TO DRIVE TRACTOR OFF SKID (See Opera-
tion section for location and function of con-
trols)
WARNING: Before starting, read, understand and follow
all instructions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
•
Be sure all the above assembly steps have been
completed.
•
Check engine oil level and fill fuel tank with gasoline.
•
Place freewheel control in "transmission engaged" po-
sition (see "TO TRANSPORT" in Operation section of
this manual).
•
Sit on seat in operating position, depress brake pedal
and set the parking brake.
•
Press lift lever plunger and raise attachment lift lever to
its highest position.
•
Start the engine. After engine has started, move throttle
control to idle position.
•
Release parking brake.
•
Slowly depress forward drive pedal and drive tractor off
skid.
•
Apply brake to stop tractor and set parking brake.
•
Turn ignition key to "STOP" position.
Continue with the instructions that follow.
7
Advertisement
Table of Contents
