Table of Contents
Advertisement
TO START ENGINE WITH A WEAK BAT-
TERY (See Fig. 29)
WARNING: Lead-acid batteries generate
explosive gases. Keep sparks, flame
and smoking materials away from bat-
teries. Always wear eye protection when
around batteries.
If your battery is too weak to start the engine, it should be
recharged. If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12
VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A
12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
•
Connect one end of the RED cable to the POSITIVE (+)
terminal of each battery (A-B), taking care not to short
against tractor chassis.
•
Connect one end of the BLACK cable to the NEGATIVE
(-) terminal (C) of fully charged battery.
•
Connect the other end of the BLACK cable (D) to good
chassis ground, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
•
BLACK cable first from chassis and then from the fully
charged battery.
•
RED cable last from both batteries.
Weak or Dead
Battery
SERVICE AND ADJUSTMENTS
Fully Charged
Battery
FIG. 29
TO REPLACE HEADLIGHT LAMP
CAUTION: When lit, the halogen lamps
get extremely hot. Hold lamp assembly
by the holder and do not touch the bulb.
•
Raise hood.
•
Disconnect harness from lamp assembly.
•
Rotate counterclockwise and pull lamp assembly out of
the hole in the backside of the grill.
•
Insert new lamp assembly and rotate clockwise to lock.
•
Reconnect harness to lamp assembly.
•
Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
•
Check wiring. See electrical wiring diagram in the Repair
Parts section.
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-in fuse. The fuse
holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 30)
•
Raise hood.
•
Unsnap headlight wire connector.
•
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
•
To replace, reverse above procedure.
24
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 30
Advertisement
Table of Contents
