Connect The Filter Support Cable - Samsung NK30CB700W Series Installation & User Manual

Installation

Connect the filter support cable

16 English
FULL_NK30CB700W33AA_DG68-01416B.indb 16 FULL_NK30CB700W33AA_DG68-01416B.indb 16
1. Remove the filter at the bottom of
the hood. Pass the filter support
cable through the wire loop attached
on the top of the filter. Make the
knot by passing the hook of the filter
support cable through the other end
of the filter support cable.
2. Hang the hook of the filter support
cable to the anchor at bottom of the
hood. Assemble the filter.
Installing the Recirculation Kit
NOTE
Same process until No. 14
Duct Cover Mounting Bracket
Deflector
Assembly
screws
A
B
C
D
Assemble the air deflector with the
1.
duct cover mounting bracket with the
four assembly screws provided with
the Recirculation Kit.
NOTE
• Use of recirculation type hoods
in closed spaces may cause poor
ventilation performance.
• Please ventilate the room by opening
the windows while operating the
device.
2. Measure from the bottom of the deflector
to the bottom of the hood outlet.
3. Cut the duct to the measured size "X."
4. Remove the deflector.
5. Slide the duct onto the bottom of the
deflector.
6. Place the assembled deflector and duct
over the exhaust outlet from the hood.
7. Reassemble the air deflector to the duct
cover mounting bracket with the four
assembly screws.
8. Seal the connections with tape.
A Deflector
X = length to cut
B
duct
C Duct
D Exhaust outlet
2023-03-30 오전 11:17:34 2023-03-30 오전 11:17:34