Connect The Filter Support Cable; Installing The Recirculation Kit - Samsung NK36CB600W Series Installation & User Manual

Installation

Connect the filter support cable

16 English
1. Remove the filter at the bottom of
the hood. Pass the filter support
cable through the wire loop attached
on the top of the filter. Make the
knot by passing the hook of the filter
support cable through the other end
of the filter support cable.
2. Hang the hook of the filter support
cable to the anchor at bottom of the
hood. Assemble the filter.

Installing the Recirculation Kit

NOTE
Same process until No. 14
Duct Cover Mounting Bracket
Deflector
Assembly
screws
A
B
C
D
1. Assemble the air deflector with the
duct cover mounting bracket with the
four assembly screws provided with
the Recirculation Kit.
NOTE
• Use of recirculation type hoods in closed
spaces may cause poor ventilation
performance.
• Please ventilate the room by opening
the windows while operating the device.
2. Measure from the bottom of the deflector
to the bottom of the hood outlet.
3. Cut the duct to the measured size "X."
4. Remove the deflector.
5. Slide the duct onto the bottom of the
deflector.
6. Place the assembled deflector and duct
over the exhaust outlet from the hood.
7. Reassemble the air deflector to the duct
cover mounting bracket with the four
assembly screws.
8. Seal the connections with tape.
A Deflector
X = length to cut
B
duct
C Duct
D Exhaust outlet