Page 3
Commercial use only! Improper use Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this prod- uct. If other spare parts or accessories are used, this could have a detrimental effect on the safety of the equipment, increase the risk of serious injury and lead to damage to the environment or the product itself.
Page 4
Send the equipment in for repair! ► Only operate the equipment under supervision. ► Please observe the national accident prevention regulations! ► Information on REACH and SVHC is available on our website at www.renfert.com, in the Support area. Specific information ►...
Service life The maximum service life strongly depends on the conditions of use, in particular on compliance with the prescribed cleaning and maintenance intervals. Authorized persons Operation and maintenance of the equipment may only be performed by trained personnel. Unauthorized persons, in particular children, are not permitted to use this equipment. Any repairs not described in these operating instructions may only be performed by a qualified electrician.
Page 6
Opening / closing the service opening Opening Observe the steps: First loosen the nuts – do not remove them! Danger due to pressurized steam! Before opening the revi- sion cap, ensure that the pressure tank is no longer pressur- ized. To do so, open the tank cap (1) and remove it. Reduce the existing pressure if required using the steam out- let function (see Chap.
Page 7
4 weeks 2 weeks Weekly With the POWER steamer 2, Renfert recommends using the Power steamer water softener (see online for accessories) to reduce water hardness. A maintenance plan is available online at www.renfert.com/p918. Enter the following item number: 18450000 or 18460000 and select "Downloads".
⇒ Screw in the tank cap and tighten until it is finger tight. The POWER steamer 1 can be operated using both drinking water and distilled or deionized water. If the unit is a POWER steamer 2 and if it was connected to the water supply, it fills automatically after it is switched on.
Page 9
♦ A short warning signal sounds. ♦ The heating is switched off. POWER steamer 1 Danger of scalding due to steam escaping when opening the tank cap and when filling! Only open the tank cap when there is no longer any pressure.
Replacing the handpiece holder A corresponding description is provided in the operating instructions, which you can download from our website at www.renfert.com/p918 (see Chap. "Introduction"). Cleaning / Maintenance The unit does not contain any internal parts that require maintenance.
Need help?
Do you have a question about the POWER steamer 1 and is the answer not in the manual?
Questions and answers