Travis Industries 99300661 Manual

Modulating Remote - Universal

CHECK CONDITION OF SHIPMENT

Upon receipt of this kit, check the condition of the packaging. Damage to the package should be noted on the carrier's freight
receipt. Any damage claims as a result of shipping must be handled through the shipper. Travis Industries will provide assistance
in resolving shipping claims or replacing items not included in the package. Please report any missing items immediately.

COMPATIBILITY

• Avalon Prairie
• FPX 35 CB (with optional blower installed)

ITEMS NEEDED FOR ASSEMBLY

• Three AAA Batteries

PACKING LIST

• Remote Receiver

FCC EQUIPMENT REQUIREMENTS

WARNING : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiver.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio TV technician for help.

CANADIAN EQUIPMENT REQUIREMENTS

This Class B digital apparatus complies with Canadian ICES-003.
Cet Appareil numerique de la classe B est conforme à la norme NMB-003 du Canada.

INSTALLATION WARNINGS

! Place the remote receiver in the location detailed in these instructions. Placing the receiver in other
locations may cause the receiver to become too hot and degrade.
! All 110 AC wiring must be done by a qualified electrician and shall be in compliance with local codes
and the National Electric Code ANSW/NFPA no. 70 (in the United States) or with the current CSA
C22.1 Canadian Electric Code (in Canada).
! This kit must be installed by a qualified technician.
! Do not connect 110 VAC to the gas control valve or on/off switch on gas heaters or the thermostat posts
on pellet heaters.
! The remote control is carefully engineered and MUST be installed only as specified. It is tested safe
when installed in accordance with this installation manual If you modify it or any of its components,
you may possibly cause a fire hazard. It is your responsibility to read all instructions before starting
installation and to follow these instructions carefully during installation.
! Disconnect the power (turn off the household breaker) and shut off the gas supply to the heater before
installing the remote control.
Page 1 of 4
• Lopi Berkshire
• Remote Control
10850 117th Place N.E. Kirkland, WA 98033
• FPX 36 DV Ember-Fyre (2000)
• Modulating Regulator
Part # 99300661
• Torx T-20 Ball-End "L" Wrench
Printed June 15, 2001