Table of Contents
Advertisement
Mechanical Installation
Mounting the Net-960CE-S MDT
The Net-960CE-S is supplied with a mounting bracket with eight 6.3mm (0.25")
holes prepared in advance for attachment to the vehicle's dashboard.
1 Affix the bracket in the desired position using as many screws as required.
2 Align the round rubber mount on the right and left sides of the Net-960CE-S with
one of the three holes provided on the sides of the bracket. Both sides should be
aligned with the same hole, meaning either the top, middle or bottom hole on
each side.
3 Attached the rubber side screws from the outside of each side of the bracket so that
it goes through the bracket hole and screws into the rubber mount, which is
attached to the Net-960CE-S. Screw it in firmly, but do not over-tighten.
Figure 4: Mechanical Installation
Advertisement
Table of Contents
