Table of Contents
Advertisement
Serial Port 2 (SER2 Connector)
Serial Port 2 is connected to the SER2 connector. It provides a maximum Baud rate
of 115,200bps and one pair of communication control handshake signals (CTS/RTS).
Serial Port 2 can switch between the following two functions as determined by the
Net-960CE-S's programmable software.
• SER2: When the Serial Port 2 is set by the application to connect to the SER2
port, it serves as a standard serial communication port for connection to external
devices.
• GPS Receiver: When the Serial Port 2 is set by the application to connect
internally to the GPS Receiver, it can receive GPS data, which makes it
especially suitable for navigation applications and traffic reports.
This means that upon software request, Serial Port 2 can switch between the
connection to the SER2 connector and the connection to the internal GPS Receiver.
For further details refer to the SER2 Connector section.
Serial Port 3 (SER3 Connector)
The Net-960CE-S optionally provides Serial Port 3 as determined by factory settings.
It can provide either of the following two features, as determined by factory settings.
• RS232 (maximum Baud rate: 115,200bps) with one pair of communication
control handshake signals (CTS/RTS).
• SAE J1708 (Baud rate: 9600bps only).
Serial Port 4 (SER4 Connector)
The Net-960CE-S optionally provides Serial Port 4 according to factory settings.
Serial Port 4 can provide either of the following two functions, as enabled by the Net-
960CE-S's programmable software:
• Default Serial Port 4 Configuration: In this configuration, Serial Port 4 serves
as a standard serial communication port for connection to external devices. Its
communication standards are RS232 (maximum Baud rate: 115,200bps) with one
pair of communication control handshake signals (CTS/RTS).
• Internal Bluetooth Module Option: In this option, Serial Port 4 is connected
internally to the Bluetooth modem and is not connected to the external serial
connector.
Advertisement
Table of Contents
