Table of Contents
Advertisement
Quick Links
We remind you that only the Esko staff, or persons having received
appropriate training, are allowed to handle, manipulate or do repairs on the system.
This copyright does not indicate that this work has been published.
All rights strictly reserved. Reproduction or issue to third parties in
any form whatever is not permitted without written authority from the publisher.
Esko reserves the right to change specifications without notice.
Document number: D2964
Status: 101208
How to get started
Kongsberg XP
Serial number: __________
Please Read This First
A Publication of: Esko-Graphics Kongsberg AS
Copyright © 1984-2014 Esko.
with
Note
P.O.Box 1016, N-3601 Kongsberg, Norway
Tel: +47 32 28 99 00 Fax: +47 32 28 85 15 / 32 28 67 63
1
Esko-Graphics Kongsberg AS
www.esko.com
Advertisement
Table of Contents
Related Manuals for Esko Kongsberg XP
Summary of Contents for Esko Kongsberg XP
- Page 1 Serial number: __________ Please Read This First Note We remind you that only the Esko staff, or persons having received appropriate training, are allowed to handle, manipulate or do repairs on the system. A Publication of: Esko-Graphics Kongsberg AS Copyright © 1984-2014 Esko.
-
Page 2: Table Of Contents
Kongsberg AS does not warrant, guarantee or make any representations regarding the use, or the results of the use of the system or the information contained herein. Esko-Graphics Kongsberg AS shall not be liable for any direct, indirect, consequential or incidental damages arising out of the use or inability to use the system or the information contained herein. - Page 3 EC DECLARATION OF CONFORMITY FOR MACHINERY Manufacturer: Esko-Graphics Kongsberg AS Address: Kirkegårdsveien 45, NO-3616 Kongsberg, NORWAY The manufacturer declares that Product: KONGSBERG Cutting Table Type: Serial number: __________ - are in conformity with the provisions of the Machinery Directive (98/37/EC), as amended, and with national implementing legislation;...
-
Page 4: Introduction
1. Introduction Dear customer Welcome to co-operation with Esko-Graphics Kongsberg. This document is a brief introduction to the system you are about to receive. 2. Where to find information The following documentation is available for the equipment Target Title Media, shipment... -
Page 5: Safety Issues
2.1 Site preparation The information you need for planning and preparing the installation of the Kongsberg XP system is described in the Site Preparation Instruction handbook. All preparations given in that handbook should be completed before the Esko-Graphics Service Engineers arrive on-site to assemble the system. -
Page 6: Unpack The Equipment
5. Unpack the equipment Only Esko-Graphics Service Engineers are allowed to unpack the equipment. 6. Installation Only Esko-Graphics Service Engineers are allowed to install the equipment. 7. Start-up and Shut-down procedures 7.1 Start up Turn on the PC. ... -
Page 7: 10. Who Are Allowed To Use The System
Damage to work materials. Esko-Graphics is not liable for use of the system when these guidelines are not followed. 10. Who are allowed to use the system? Only personnel trained by Esko-Graphics authorized personnel are allowed to operate the system.
Need help?
Do you have a question about the Kongsberg XP and is the answer not in the manual?
Questions and answers