Craftsman C459-62206-1 Operator's Manual page 9

4.
Top Hex Screw
Handle Bracket Assembly
Flat Washer
Rubber Washer
Cotter Pin
ATTACHING THE HANDLE SWIVEL ROD
1. Make sure the handle assembly is in the highest position. Refer to
the Operation Section.
2. Remove the cotter pin and T-knob from the handle swivel rod.
3. Slide the handle swivel rod through the upper handle assembly,
insert the lower end of the rod into the swing handle link and
secure with the previously removed hardware. See Figure 5.
4. See Figure 5.
ASSEMBLY
Handle
Handle
Assembly
Adjustment Crank
Retainer
Bracket
Flange Lock Nuts
Figure 3
T-Knob
Figure 4
Nut
T-Knob
Lock
Washer
Adjustable Fitting
ATTACHING THE CLUTCH CABLE
1. Loosen the upper nut on the cable and slide the nut and washer
off the adjustable fitting. See Figure 6.
2. Slide the cable into the cable bracket as shown in Figure 6.
3. Replace the washer and the upper nut on the adjustable fitting
and tighten.
NOTE: Do not overtighten the clutch cable. Too much tension may
cause it to break. Be certain to check the clutch cable adjustment before
operating the tiller. See page 10 for cable adjustment instructions.
9
Swing Handle Link
Cotter Pin
Figure 5
Side View
Figure 6