4-5. White Ratio (Balance) Adjustment
1.
You can adjust the white ratio in factory mode (1:Calibration, 3:White-Balance).
2.
Since the adjustment value and the data value vary depending on the input source, you have to adjust these in CVBS,
Component 1 and HDMI 1 modes.
3.
The optimal values for each mode are configured by default. (Refer to Table 1, 2) It varies with Panel's size and
Specification.
•
Equipment : CS-210
•
Pattern: MIK K-7256 #92 "Flat W/B Pattern" as standard
•
Use other Equipment only after comparing the result with
that of the Master equipment.
•
Set Aging time : 60min
•
Calibration and Manual setting for WB adjustment.
HDMI : Calibration at #24 Chessboard Pattern Manual adjustment #92 pattern (720p)
COMP : Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (720p)
CVBS : Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (NTSC)
NOTE
•
If finishing in HDMI mode, adjustment coordinate is almost same in AV mode.
•
White Balance Manual adjustment.
4. Troubleshooting
4-25