Table of Contents
Advertisement
Matrix 908 Field Computer
NO.3 CREATE AN APPLICATION BOUNDARY
Application boundaries establish the work areas where product is or is not applied while using Automatic Section Control (ASC) or
BoomPilot.
Application is not required to map a boundary. Boundary will be mapped to the edge of all the programmed sections (not necessarily
those turned on at any given time during the boundary pass) or a user selected mapping location (see "No.6 Set Up Mapping Location"
on page 20 for details). External boundaries map to the outer edge of the programmed sections. Internal boundaries map to the inner
edge of the programmed sections.
Establishing an Exterior or Interior
Boundary
1. Drive to a desired location at the perimeter of
the application area and orientate the vehicle in
association to the established mapping location.
2. With the Boundary button
active, press the Slide-Out Tray button
3. Select the type of boundary to be mapped.
Exterior Boundary – establishes a work
area where application will be applied while
using ASC or BoomPilot
Interior Boundary – establishes a non-work
area where application will NOT be applied
while using ASC or BoomPilot
4. Press MARK BOUNDARY icon
Start Exterior Boundary
Start Interior Boundary
5. Acknowledge which mapping location will be used.
34
www.teejet.com
on the Feature Bar
.
Advertisement
Table of Contents
