Table of Contents
Advertisement
en Installation instructions
¡ Seal the cut surfaces of wooden work surfaces with
a special glue seal to protect them from moisture.
¡ Any adjoining vertical wall surface situated within
200 mm from the edge of any cooktop burner must
be a suitable non-combustible material for the entire
length of the cooktop, in accordance with clause
6.10.1.2 of AS/NZS 5601.1.
Preparing the furniture item for flush installation
¡ All cutting work on the work surface must be carried
out in a specialist workshop.
¡ The cuts must be clean and precise because the
cutting edge is visible on the surface. The stability of
the units must also be ensured after the cutting
work.
¡ Only use special, temperature- and water-resistant
work surfaces (e.g. natural stone or tiles).
¡ The fitted unit must be heat-resistant up to 90 °C.
2.3 Clearances
¡ A range hood fitted above the top must be installed
according to the installation instructions for the
range hood. A minimum distance of 650 mm is re-
quired for a range hood and 750 mm for an exhaust
fan.
8
¡ Any combustible construction above the cooktop
must be at least 650 mm above the top of the
burner and no construction shall be within 340 mm
above the top of the burner.
¡ Height of the pan support above the worktop sur-
face: up to 60 mm.
¡ A minimum depth of 50 mm from the top of the
worktop surface must be provided for the appliance.
Advertisement
Table of Contents
