Product Parameters - Dahlert DT-WP-22 Instruction Manual

3. As shown below:
① Follow the steps shown below to replace the filter.
Remove the water tank
Put in the new filter and press the
lever until hearing the "click" sound
② After replacing the filter, hold the Filter Reset button for 3 seconds to reset the filter life.
Service guide

Product Parameters

For the technical improvement of the product, the following parameters are subject to change
without prior notice, please refer to the nameplate of the product.
The purified water flow rate is tested when the environment temperature 25±2°C and water
temperature 25± 1°C.
Model
Rated voltage/ frequency
Rated hot water capacity
Rated power
Rated total purified water amount
Purified water flow
Inlet water pressure
Working pressure
Applicable water quality
Applicable water
Applicable ambient temperature
Water treatment process diagram
Municipal tap water→Integrated composite filter→PP sediment filter→Fiber activated carbon
→Nanofiltration membrane→Activated carbon rod→Water output
Open the top cover
Filter Reset
→
Waste water
Open the filter handle
After closing the top cover,
place the water tank
3 seconds
DT-WP-22
220-240V~ 50/60Hz
≥90°C, 20L/h
2190W
2500L
0.2L/min
0.05-0.1MPa
0.45-0.8MPa
Municipal tap water
Tap water TDS ≤350 ppm
4-38°C
7
Lift the old filter