Related Manuals for Oregon Scientific PSM01A
Summary of Contents for Oregon Scientific PSM01A
- Page 1 Full Weather Station with Radio Controlled Clock (Model #: PS-M01 / PS-M01U) User Manual PS M01 English Cover R7 op 7/24/03, 10:42 AM Black...
-
Page 2: Table Of Contents
TABLE OF CONTENTS About this guide ... 2 Product overview ... 3 Getting started ... 8 Batteries ... 8 AC power adapter ... 8 Switch between modes ... 8 Change settings ... 9 Remote unit set up ... 9 Clock ... 10 Alarm ... -
Page 3: About This Guide
ABOUT THIS GUIDE Congratulations on your selection of the Philippe Starck with Oregon Scientific Full Weather Station with Radio- Controlled Clock (PS-M01 / PS-M01U). This powerful device bundles time keeping, alarm, indoor and wireless outdoor temperature and humidity monitoring, and weather forecasting into a single tool you can use from the convenience of your home. -
Page 4: Product Overview
PRODUCT OVERVIEW TOP VIEW PS M01 English R17 op Black DESCRIPTIONS Snooze / Light button Light sensor 7/24/03, 10:57 AM... - Page 5 LCD DISPLAY PS M01 English R17 op Black DESCRIPTIONS Low battery icon Clock Barometer Weather forecast Moon phase Calendar Temperature and humidity Alarm 7/24/03, 10:57 AM...
- Page 6 BACK VIEW PS M01 English R17 op Black BUTTON DESCRIPTIONS Select - switch modes / change settings Up - increase setting / activate auto-synch Down - decrease setting / deactivate auto-synch Channel - switch remote unit Alarm - activate / deactivate alarm 7/24/03, 10:57 AM...
- Page 7 BOTTOM AND SIDE VIEW PS M01 English R17 op Black DESCRIPTIONS Battery compartment Backlight switch Reset button Light sensitvity knob DC Power input jack NOTE AC power adapter not shown. 7/24/03, 10:57 AM...
- Page 8 REMOTE UNIT PS M01 English R17 op Black DESCRIPTIONS Temperature / Trend display Low battery icon Humidity / Trend / Comfort Level display °C/°F switch Channel switch Reset button Battery compartment Wall-Mount hole Battery compartment lid 7/24/03, 10:57 AM...
-
Page 9: Getting Started
GETTING STARTED BATTERIES Batteries for the remote and main units are supplied with this product. Replace them whenever the low battery signal ( ) displays. Remove the battery compartment lid on the bottom of the main unit, and insert the batteries. You will need a small Phillips screwdriver to remove the remote unit compartment lid. -
Page 10: Change Settings
CHANGE SETTINGS Press and hold SELECT for 2 seconds. Then, press UP or DOWN to change each setting. Press SELECT to switch options. REMOTE UNIT SET UP Up to 3 remote units can be used with this product to monitor outdoor temperature and humidity. The measurement unit (°C or °F) and channel number (1, 2, or 3) switches are located in the battery compartment, and should be set prior to installation. -
Page 11: Clock
CLOCK This product can automatically synchronize the date and time with official time-keeping organizations in Frankfurt, Germany (PS-M01) or Rugby, England (PS-M01U). When the unit is within 1500 km (932 miles) of a RF signal, the reception icon will blink during reception. RECEPTION Reception takes 2 - 10 minutes to complete. -
Page 12: Alarm
SET OR CHANGE THE CLOCK Press SELECT to switch to the Clock Mode. The time will flash. Press and hold SELECT for 2 seconds to enter the setting mode. Select the 12/24-hour format, hour, and minute. Press UP or DOWN to change the setting. Press SELECT to confirm. -
Page 13: Calendar
TO TURN THE ALARM OFF OR ON Press any button to stop the alarm. To turn the alarm off completely (deactivate it for the next day), press ALARM. CALENDAR SET DATE Clock auto-synchronization must be deactivated before you manually set the date. ( Press SELECT several times until the calendar area flashes. -
Page 14: Barometer
BAROMETER This product tracks barometric pressure changes over the past 24 hours to provide the weather forecast 14) and a trend line showing the direction of barometric change. Barometric changes are measured by the main (indoor) unit. BAROMETRIC TREND The barometric trend arrow for the last 30 minutes is always displayed. -
Page 15: Weather Forecast
SET UNIT AND ALTITUDE You can set the unit of measurement (mb/hPa or inHg) and altitude. Setting the altitude allows the product to take more accurate barometric measurements. Press SELECT 2 times until the Barometer Area flashes. Press and hold SELECT for 2 seconds. Select altitude (-100 meters to 2500 meters in increments of 10) and the unit of measurement (mb/hPa or inHg). - Page 16 Outdoor measurements are collected by the remote unit. Temperature is give at the top; humidity is below. VIEW MIN / MAX / CURRENT MEASUREMENTS Press SELECT 3 times until the Temperature and Humidity Areas flash. Press UP or DOWN to scan the readings.
- Page 17 Searching No sensor Sensor found NOTE Signals from household electrical appliances such as doorbells and home security systems can cause temporary reception failures between the indoor and outdoor units. This is normal and does not affect the general performance of the product. Reception will automatically resume once the interference ends.
-
Page 18: Backlight
TRENDS The trend arrow for the last 30 minutes always displays. Indoor and outdoor temperature and humidity trends are shown separately. Trend Temperature Relative Humidity + 0.5 °C + 3% Steady Steady -0.5 °C PS M01 English R17 op Black SET UNIT While in Temperature / Humidity Mode, press SELECT for 2 seconds. -
Page 19: Reset System
Move it to the “AUTO” position to enable continuous backlight controlled by light intensity. When activated, the backlight will be on whenever the unit perceives that the room is dark. The Light sensitivity knob is located in the battery compartment. Rotate to adjust. LIGHT SENSOR LIGHT ON OFF... -
Page 20: Warnings
WARNINGS This product is designed to give you years of service if handled properly. Observe the following guidelines: • Never immerse the unit in water. This can cause electrical shock and damage the unit. • Do not subject the main unit to extreme force, shock, or fluctuations in temperature or humidity. -
Page 21: Troubleshooting
TROUBLESHOOTING Check here before contacting our customer service department. Problem Symptom Remedy Shows “LLL” or Temperature is out-of- Temp “HHH” range. Calendar Strange date / Change language month Backlight No continuous Plug in AC power backlight adapter. Check the BACKLIGHT switch. 8, 17) PS M01 English R17 op Black... -
Page 22: Specifications
Problem Symptom Remedy 4. Place clock near window / away from electrical devices, and wait 10 - 20 minutes. If it still fails, you may be too far from a signal. Cannot change Disable auto- clock synchronization Baro Strange reading Set altitude / unit PS M01 English R17 op Black... - Page 23 0.1 °C (0.2° F) Resolution 20 °C to 25 °C (68 °F to 77 °F) Comfort (see also, Relative humidity) Memory Minimum / maximum + /- 0.5 °C ( + /- 0.9 °F) change Trend Relative humidity Range Main & Remote Unit: 25% to 95% Resolution Comfort 40% to 70%...
-
Page 24: Additional Resources
Channel No. 1, 2, or 3 °C or °F Unit Radio-controlled clock Synchronization Auto or disabled Clock display HH:MM:SS Hour format 12hr AM/PM (MSF format) 24hr (DCF format) Calendar DD/MMM; weekday selection in 5 languages (E, D, F, I, S) Moon phase High, medium, and low tide Alarm... - Page 25 R&TTE Directive 1999/5/EC (appendix II) and carries the respective CE marking. VS-Villingen / Germany August 2003 Gerhard Preis R&TTE Representative of manufacturer RTT&E Compliant Countries: All EC Countries, Switzerland and Norway ©2003 Oregon Scientific. All rights reserved. 7/24/03, 10:57 AM...