Table of Contents
Advertisement
Spyglass IR3-V
Flame detector
USER MANUAL
3.6 Mounting the detector
Use the following steps to connect the detector to the tilt mount, referring to
a) Place the detector, with its cable/conduit entries pointing down, on the holding plate of the tilt
mount (item 2, Figure 13).
b) Secure the detector to the plate using the two hex screws and spring lock washers (items 3 and 4).
c) Loosen the locking screws (Items 5 and 6, Figure 13) in such a way that enables you to rotate the
detector.
d) Point the detector towards the detection area and make certain that the view of the area is
unobstructed.
e) Secure the detector in that position by tightening the locking screws (Items 5 and 6) on the tilt mount.
(Make sure the detector is pointing in the correct direction).
The detector is now correctly mounted, aligned and ready for electrical connection. Please refer to
section 3.7 for wiring instructions, and section 4 for a description of the detector's configuration settings.
Item N°.
1
2
3,4
5
6
14
Figure 13 : Detector on Tilt mount – Side view
Item name
Tilt mount assembly
Holding plate
Mounting HEX screws M8 and lock washers
HEX socket locking screw M8
HEX socket locking screw M12
:
Figure 13
SG50FIR3V-EN
Revision 1.0
Advertisement
Table of Contents
