Page 1
MODEL 2725 Aqueous Combination Unit Operating Manual _________________________________________________________________________________________________________________________ Heritage Crystal-Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
Page 2
Some improvements may have been made after this manual was printed. For the latest information on your equipment, contact your HCC representative. Heritage-Crystal Clean, LLC, 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
11. Use only as described in this manual. Use only manufacturer’s recommended attachments. 12. The ambient air temperature should not be below 40F or above 105F. 13. Do NOT modify these machines. “SAVE THESE INSTRUCTIONS” Heritage-Crystal Clean, LLC, 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
In the event that the lid is lifted mid-cycle, the limit switch will cease all operation of the turntable and pump. NEVER Modify or defeat the limit switch. An unsafe condition may occur if any unauthorized changes are made. Heritage-Crystal Clean, LLC, 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
MODEL 2725 INSTALLATION The 2725 is a high capacity, compact footprint, and self-contained parts washer. The only external hookup is a 120VAC, 1PH, 14A minimum dedicated electrical supply line. Floor plan layout should include adequate access for maintenance, service, and repair. Vertical clearance should allow full opening and closing of the lid without obstruction.
FLA: 13A ELECTRICAL HOOK-UP The 2725 comes fully wired with a GFCI protected standard 120VAC plug. The voltage, phase, and current draw of the machine are listed above and on the serial number plate. Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
Page 7
OPERATING INSTRUCTIONS REMOVAL OF THE GFCI PROTECTION DEVICE ( ELECTRICAL CORD ) WILL VOID THE WARRANTY ON THE MODEL 2725 AND MAY CAUSE PERSONAL INJURY OR SHOCK. INPORTANT DO NOT USE EXTENSION CORDS WITH A WIRE GAUGE SIZE SMALLER THAN 12/3.
Page 8
SWING AWAY SPRAY BAR Swing Away Spray Bar • Overhead load friendly • Large object friendly • Can move either direction to be completely clear of the turntable area Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
Page 9
Use an air blow off gun to make sure all filter holes are clean. Give the filter a final rinse, then reinstall the filter tube. Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
Page 10
The maximum detergent level is at this marker. Maintain level at this marker. Low level is 1 to 1-1/2” below the marker. Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
Page 11
Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
Page 12
4) Remove bearings and spacer. Clean and inspect bearings. 5) Reinstall clean or new parts. Before re-inserting spindle shaft, fill tube 1” deep with motor oil. Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
Page 13
MODEL 2725 NEW GFCI CONFIGURATION Updated machines will have an internally mounted GFCI with a red TEST switch and green RESET switch. Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
Page 14
• It is common for the top bearing to slip off when the machine is being services – always make sure to look for this top washer before installing the turntable support rack Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
MODEL 2725 TROUBLESHOOTING CHECKLIST Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
Page 16
MODEL 2725 MACHINE RETURN FORMS AND SHIPPING CAPS ARE MANDATORY Heritage-Crystal Clean, LLC 2000 Center Drive, Suite East C300 Hoffman Estates, IL 60192 877-938-7948...
Need help?
Do you have a question about the 2725 and is the answer not in the manual?
Questions and answers