Table of Contents
Advertisement
5.2 STORAGE
When storing unit for extended periods of time, remove
all fuel from tank and carburetor (run dry). Refer to
Engine Manual.
5.3 CHECK FASTENERS
Keep all nuts, bolts, and screws properly tightened.
5.4 CLEAN ENGINE COOLING SYSTEM
Engine is air cooled. Air must circulate freely around
engine to prevent overheating.
Every year (more often if conditions require) remove
cooling shrouds and clean cooling fins. Clean external
surfaces of engine of dust, dirt and oil deposits which
can contribute to improper cooling. Refer to Engine
Manual.
IMPORTANT: DO NOT operate engine with cooling
shrouds removed. Engine overheating and damage will
result.
The engine on the Sno-Thro is a 2-cycle design. The
lubricating oil is mixed with the gasoline. Consult the
engine manufacturers manual for the proper grade and
mix ratio.
3
1. Hex Bolt
2. Drive Pulleys
Figure 7
5 - 14
5.5 REMOVE ENGINE
1. Remove gas cap and top cowling.
2. Remove fuel line at the engine and drain fuel into a
suitable container. Save for reuse or dispose of
properly.
3. Remove drive belt from engine pulley.
4. Remove bolt and washer from engine shaft and
slide drive pulley halves from shaft.
5. Disconnect throttle cable from engine.
6. On models with recoil starters, unbolt the bracket
that holds the recoil handle to the lower handle bar.
7. Remove wiring for key switch.
8. Unscrew bolts from shaft side of engine.
9. Unscrew mounting nuts on recoil side.
10.Disconnect choke cable.
11.Remove engine.
Install in reverse order.
1
2
3. Engine Mounting
Bracket
PS0034
Advertisement
Table of Contents
