Viewfinder Adjustment; Tape Length/Recording Mode Setting; Loading/Unloading A Cassette - JVC GR-AX210 Instructions Manual

Downloaded from: https://www.usersmanualguide.com/
SP-LP recording mode and
T30•45 tape length select button
Set POWER to "CAMERA".
Tape length and recording
mode indicator
T30 SP
T30 SP
T45 LP
Turn to take up
slack.
Erase Protection Gear

Viewfinder Adjustment

POSITION VIEWFINDER
1
Adjust the viewfinder manually for best viewability
(see illustration at left).
SELECT MODE
2
Set the power switch to CAMERA.
ADJUST DIOPTER
3
Turn the diopter adjustment control until the
indications in the viewfinder are clearly focused.

Tape Length/Recording Mode Setting

SET TAPE LENGTH
1
Set the tape length button according to the length of
the tape used. T30 = 30 minutes of recording time
and T45 = 45 minutes (in SP).
SET RECORDING MODE
2
Set depending on your preference. "SP" (Standard
Play) provides higher picture and sound quality and
is better for dubbing, while "LP" (Long Play) is
more economical, recording at 1/2 the speed of SP.
T30 LP

Loading/Unloading A Cassette

T45 SP
OPEN CASSETTE HOLDER
1
Slide EJECT until holder opens. Do not use force to
open.
INSERT/REMOVE CASSETTE
2
Make sure label is facing outward.
CLOSE CASSETTE HOLDER
3
Press PUSH and make sure the holder is closed and
locked.
NOTES:
● A cassette holder can't be opened unless a power
supply is attached.
● Make sure that the tape is not slack when loading the
cassette. If there is any slack, turn the gear on the
cassette in the direction of the arrow to take up the
slack.
● Make sure the Erase Protection tab is present. If not,
cover the hole with adhesive tape. (Some cassettes
have sliding tabs – in this case, check the tab's
position.)
9