Siemens SIMATIC S7-300 Equipment Manual page 69

Industrial ethernet / profinet cp 343-1 lean
Hide thumbs Also See for SIMATIC S7-300:
Table of Contents

Advertisement

ATEX / IECEx / UKEX / CCC-Ex
Note the information in the document "Use of subassemblies/modules in a Zone 2 Hazardous
Area", which you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
The conditions must be met for safe usage of the product according to the section
AUTOHOTSPOT.
Observe installation guidelines
The product meets the requirements if you observe the following during installation and
operation:
• The notes in the section Installation, connection, commissioning, removal (Page 33)
• The installation guidelines in the document /12/ (Page 76)
The product meets the explosion protection requirements outlined below.
IECEx
Classification: Ex ec IIC T4 Gc, Certificate no.: IECEx DEK 18.0019X
The product meets the requirements of the standards:
• IEC 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
• IEC 60079-7 - Explosive Atmospheres - Part 7: Equipment protection by increased safety 'e'
ATEX
Classification: II 3G Ex ec IIC T4 Gc, Certificate no.: DEKRA 18ATEX0027 X
The product meets the requirements of the standards:
• EN IEC 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
• EN 60079-7 - Explosive Atmospheres - Part 7: Equipment protection by increased safety 'e'
UKEX
Classification: Ex ec IIC T4 Gc, Certificate no.: DEKRA 21UKEX0003 X
The product meets the requirements of the standards:
• EN IEC 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
• EN 60079-7 - Explosive Atmospheres - Part 7: Equipment protection by increased safety 'e'
Importer UK: Siemens plc (see above)
CP 343-1 Lean
Equipment Manual, 01/2023, C79000−G8976−C198−09
WARNING
Approvals
69

Advertisement

Table of Contents
loading

Table of Contents