Table of Contents
Advertisement
2. Connect the blue (neutral) wire to the
terminal which is marked with the
letter 'N' or coloured blue.
3. Connect the brown (live) wire to the
terminal which is marked with the
letter 'L'. It must always be connected
to the network phase.
3.9 Attaching the seal - On-top
installation
1. Clean the worktop around the cut out
area.
3.10 Assembly
min.
650 mm
A
< 20 mm
min. 500 mm
A
B
12 mm
57 mm
28 mm
41 mm
38 mm
31 mm
min.
600 mm
min.
2mm
min. 2 mm
B
min
30 mm
2. Attach the supplied seal stripe to the
lower edge of the hob, along the
outer edge of the glass ceramic. Do
not stretch it. Make sure that the
ends of the seal stripe are located in
the middle of one side of the hob.
3. Add some millimetres to the length
when you cut the seal stripe.
4. Join the two ends of the seal stripe
together.
min. 2 mm
A
> 20 mm
min. 500 mm
A
B
12 mm
57 mm
28 mm
41 mm
38 mm
31 mm
ENGLISH
11
B
Advertisement
Table of Contents
