John Lewis Anna swinging crib Instruction Manual page 4

Step 2
Part B
Part A
Fixing 10
Part C
Fixing 8
Fixing 2
Fixing 7
Insert one wooden dowel (fixing 10) into the top pre-drilled hole at each end of the
crossbeam (part C). Fix the crib feet (part A and part B) to the crossbeam (part C) using
one 50mm bolt (fixing 2) and one barrel nut (fixing 7) at each end as shown. If necessary,
use a flat-headed screwdriver to ensure that the slots in the barrel nut (fixing 7) point
towards the holes in the crib feet (part A and part B). Use the allen key (supplied) to
engage the bolts into the barrel nuts. Tighten all fixings fully.
Step 3
Part E
Part D
Part E
Fixing 2
Part F
Part E
Part D
Fix the side rails (part E) to one of the crib ends (part D) using two 45mm bolts (fixing 3)
at either side as shown. Note: the groove in the side rails (part E) should be on the
inside. Carefully slide the base (part F) through the grooves in the side rails (part E) and
into the crib end (part D). Carefully fit the other crib end (part D) onto the base
(part F) and secure to the side rails (part E) using two 45mm bolts (fixing 2) at either
side. Tighten all fixings fully.
4