Using The Remote Control - Optoma HD8000-LV User Manual

User Controls
18

Using the Remote Control

Refer to the "Power On/Off the Projector"
Power
section on pages 13-14.
Adjust the brightness of the image.
Brightness
Control the degree of difference between
Contrast
the lightest and darkest parts of the picture.
Image AI Switch the Image AI function ON/OFF.
(refer to page 32-33)
Gamma
There are 10 preset gamma curves. After
the initial setup and fine tuning is complet-
ed, utilize the Gamma Adjustment steps to
optimize your image output.
Refer to "IRIS" function on page 33 for
IRIS
more information.
Brite Mode
Increase the brightness of the image. (refer
to page 35).
/ Shifts the projected image position verti-
cally.
Image Shift
Edge Mask Choose "On" to mask off a few pixels on
each edge of the image to be displayed. Use
Edge Mask "On" if image source happens
to have encoding error near any edge of the
displayable image.
Mode Select the display mode from Cinema,
Bright, TV, sRGB and User.
Menu
Press "Menu" to launch the on-screen
display (OSD) menu. To exit OSD, Press
"Menu" again.
Four Direc-
Use
tional Select
ments to your selection.
Keys
Enter Confirm your item selection.
Overscan Mask off a few pixels on each edge of the
image to be displayed. Use this function
to adjust if image source happens to have
noise near any edge of the display image.
Scale the image at a 4:3 aspect ratio.
4:3
to select items or make adjust-