Table of Contents
Advertisement
N
N
ote
ote
Steady light =>
No light =>
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will not
turn on until the lamp module has been replaced. To replace the
lamp, follow the procedures in the "Replacing the Lamp" section
on page 41.
Projector Status Indication
LED states
Message
Standby State
(Input power cord)
Power on (Warming)
Power on and Lamp
lighting
Power off (Cooling)
Error (Lamp fail)
Error (Thermal fail)
Error (Fan fail)
Error (Over Temp.)
Message Reminders
Fan failed:
Appendices
Power LED
Power LED
(Red)
(Blue)
Flashing
Flashing
Temp-LED
Lamp-LED
Flashing
Flashing
39
Advertisement
Table of Contents
