Support And Troubleshooting - IHOS KOS Satelite Set User Manual

A Make sure the power cable connection is plugged in tightly and turn right to the ON position.
B Make sure all cables and other connected devices are properly and securely connected.
No sound from
C Make sure the DSP and LEVEL setting gears are in the position corresponding to the normal gears.
the loudspeaker
D Make sure the sound source device is functioning properly and can play the desired signal.
E Check if the level setting is too low, adjust the output level setting of the sound source device, or increase
the output level with the LEVEL control.
A Make sure the power input is normal.
Loudspeaker has
B Check the cables for bends, shorts, or breaks.
hum or buzz
C Check whether the signal cable is in good contact.
If the signal indicator light is solid red, it means the output volume is too loud, adjust the output level setting
D
of the audio source device, or use the LEVEL controller to adjust the output level.
Different sound
Set each speaker's DSP switch and LEVEL switch to the same position.
for each speaker
Sound breaks up
Please wait until the amplifier cools down. If the device does not reset automatically, turn the power off and
on again.
suddenly

SUPPORT AND TROUBLESHOOTING

TROUBLESHOOTING
23