Hasbro TIGER ELECTRONICS i-Cubie Instruction Manual page 12

1. Press remote button #11 to enter VOICE Command
training mode. The eye pattern will show it is ready
(Left Green On). (you must always hold the remote
close to i-Cybie's chest)
2. Press the corresponding Remote Control Button to
the action that you want to voice train and wait for both
eyes to turn ORANGE. When they are both ORANGE
say the word once clearly and wait for the eyes to
change color. * There are 8 different VOICE Commands
that you will be programming i-Cybie to recognize. Each
button, #1 through #8, is assigned a different action
(page 23 ). To train i-Cybie to recognize your voice you
will need to go through them ONE at a time. Also
the word that you train i-Cybie to recognize is your
choice. You can either use the word that corresponds
to the action, as shown below, or you can make-up your
own word or phrase! But i-Cybie reaction to the word
will remain the same.
* Repeat sequence again.
Read bottom of page 22.
21
3. After hearing the voice, the system will
do the training. If it is ok, then both of
the eyes will turn green. If it fails, one
eye will be red and one eye will be green.
4. To train the next word, move to the next
button and repeat steps 2 & 3.
Every single button from #1 - #8 must be trained
for the VOICE Recognition to function
5. To EXIT VOICE training press #12 on the Remote Control.
22
US