Page 1
WE-EF LIGHTING Installation and Maintenance Instructions Wall Luminaire Surface Mounted FLC122 LED FLC142 LED Surge Protection Do not open during installation This product is factory-sealed. This product features built-in surge protection circuitry in compliance with Refer to the instructions contained in this applicable standards.
Page 2
Wall Luminaire Surface Mounted FLC122 FLC142 IP55, IK07, Class I, ta= 40°C...
Light Source Maintenance Apart from cleaning the product’s exterior surfaces, no special maintenance work is required. Do not use high-pressure cleaners. In case of component failure due to abnormal circumstances or at end of life, replacement must be carried Warning: Do not open luminaire while mains supply is switched on.
Installation The product must be installed and maintained by a building/construction and/or electrical regulations and relevant legislation. Warning: Notice: no longer be valid and shall become the full responsibility of the modifying person/organisation. Claims based on defects attributable to improper installation and/or application, and the consequences thereof, are excluded.
Installation Procedure A by loosening screws B. 3) Check that rating shown on luminaire label D. Drill relevant holes E and insert nylon plugs F. conforms with mains electrical supply. Warning: Ensure not to damage any electrical cable, water pipe or other items drilling holes. 12/17 IP55 FLC122-LED 120-277V/60Hz...
Page 6
5) Feed mains supply cable G (and second cable A, pierce through nylon H for through wiring, if required) through plugs J by inserting and tightening screws D. Attention: Nylon plugs J must remain in A in position. position to provide sealing. 7) Connect mains supply cable G leads to 8) Ensure that all surfaces are clean and dry.