Advertisement
5) Feed mains supply cable G (and second cable
H for through wiring, if required) through
I
A in position.
7) Connect mains supply cable G leads to
respective terminals in of LED Driver K:
a) ON/OFF (L = Phase, N = Neutral,
= Earthing)
b) 0-10 V (L = Phase, N = Neutral,
= Earthing, D–/D+ = 0-10 V control line).
plugs J by inserting and tightening screws D.
Attention: Nylon plugs J must remain in
position to provide sealing.
8) Ensure that all surfaces are clean and dry.
Tighten screws B.
5
A, pierce through nylon
A.
Advertisement
