Disposal And Recycling - EINHELL FORTEXXA 18/20 TH Operating Instructions Manual

Remove the adapter plate (Item 20) from the bar
as shown in Fig. 17. Now fi t the adapter plate to
the new bar. Proceed as described in the section
"Assembly of the bar and the saw chain".
Checking the automatic chain lubrication
You should check the operation of the automatic
chain lubrication system on a regular basis
in order to guard against overheating and the
associated damage to the bar and the saw chain.
To do this, point the tip of the bar towards a
smooth surface (board, section of a cut tree) and
allow the chain saw to run.
If an increasing oil trace becomes evident during
this process, then the automatic chain lubrication
system is working properly. If no clear oil trace is
evident then please refer to the corresponding
instructions in "Troubleshooting". If the information
contained there still fails to remedy the situation
then please contact our service department or
another similarly qualifi ed workshop.
Danger! Do not actually touch the surface with
the tip of the bar when performing this test. Keep
a safe distance (approx. 7.9" (20 cm)).
Sharpening the saw chain
Eff ective working with the chain saw is only
possible if the saw chain is in good condition and
sharp. This also reduces the risk of kickback.
The saw chain can be re-sharpened by any
dealer. Do not attempt to sharpen the saw chain
yourself unless you have the necessary special
tools and experience.
7.3 Transport
Engage the chain brake.
To avoid injury, always carry the device with
the chain saw guard fi tted. Follow the generally
applicable regulations on securing loads.
Anl_Fortexxa_18_20_SPK7_USA.indb 20 Anl_Fortexxa_18_20_SPK7_USA.indb 20
EN

8. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 41°F and 86°F
(5°C and 30°C). Keep the electric tool in its
original packaging.
The reprinting or reproduction by any other
means, in whole or in part, of documentation
and papers accompanying the products is
strictly subject to the express consent of Einhell
Germany AG.
Subject to technical changes.
- 20 -
29.11.2022 14:42:44 29.11.2022 14:42:44