Faber FCH 84 GR KL User Manual page 14

10. USER MENU CUSTOMISATION
Before carrying out the procedure, it is advisable to read the entire paragraph.
– Press .
– Press and hold
– The key starts flashing.
– Press and hold
– Hold and start pressing the digit of the cooking areas in clockwise order starting from the left front one.
The rear left digit alternately indicates
The front left digit indicates a number which depends on the parameters indicated in the selection.
– Press the left rear digit.
– Select a number on the power bar to access the menu code.
– Press the left front digit.
– Select a number on the power bar to select a value.
– Once the correct value has been entered, confirm by touching and holding
– To exit the menu without saving, press
If no operation is carried out the user menu will close after 1 minute.
See the following table for the specifications:
Menu code Description
U2 Key sound volume control menu. 0 - Sound disabled
U3 Countdown beeper volume control
menu.
U4 Display brightness level control
menu.
U5 Countdown display control menu. 0 - Countdown display disabled
U6 Pan detection menu.
U7 Countdown
menu.
U9 Menu to activate Hob-Hood
Coupling.
14
again for 3 seconds.
: the digits in the cooking area indicate
2
1
and a number from 2 to 9 indicating the menu code.
.
Value
1 - Min.
3 - Max.
0 - Sound disabled
1 - Min.
3 - Max.
0 - Max.
9 - Min.
1 - Countdown display enabled
0 - Enabled
1 - Disabled
end management 0 - Continuous flashing and shut-down
1 - Ten flashes and shut-down
2 - One flash and shut-down
0 - Hob-Hood Coupling disabled
1 - Activate Hob-Hood Coupling procedure. The display shows an anima-
tion.
WARNING: once the procedure has been activated, refer to the hood
manual and check that the K-Link Coupling procedure has been activated.
The coupling procedure takes 2 minutes.
.
3
4
for 2 seconds.