Table of Contents
Advertisement
Error codes
Error code
E01
E02
E03
E04
E05
E06
E07
E08
E09
E10
E11
E12
E13
E14
E15
E16
Note: IPS-0008 detects the phase of the input source automatically. If
the phase is opposite to that of the outlet phase, the outlet is turned off.
The corresponding error code is displayed on the input power status
indicator on the front panel with the error code and a message is
displayed in a pop-window from your browser. The log is updated with
information about this event. To prevent this condition from occur- ring,
select the Control Group submenu under the IPS-0008 Configuration
Menu and set the Input Phase Detection item to Disabled.
Description
Network link down
Parameters checksum error
Input voltage over threshold high (Volt)
Input voltage over threshold low (Volt)
Outlet A current over threshold (Amp)
Outlet B current over threshold (Amp)
Outlet C current over threshold (Amp)
Outlet D current over threshold (Amp)
Outlet E current over threshold (Amp)
Outlet F current over threshold (Amp)
Outlet G current over threshold (Amp)
Outlet H current over threshold (Amp)
Input source abnormal (for 110V model)
Input source abnormal (for 220V model)
Input current sensor value abnormal
Input source phase incorrect (see note below)
37
Advertisement
Table of Contents
