Table of Contents
Advertisement
The following procedure describes the basic steps needed to set up the
IPS-0008:
1.
To set up the hardware, connect power to the power inlet and
output devices to the power outlets. Connect digital outputs to the
digital I/O ports, and an EMD to the console port.
2.
To configure the IPS-0008, you can use the console or WAN port.
Connect the IPS-0008 to a console and a WAN to enable its
configuration through the console or browser menu.
3.
After connecting to a console, use a console application such as
Tel- net or HyperTerminal to access the console menu. Select the
System Group submenu under the IPS-0008 Configuration to set
up the IP address and the system date/time. This IP address will be
used while accessing the web interface to configure the IPS-0008
parameters.
4.
After connecting to WAN, open a browser from a PC in the network
and use the IPS-0008 IP address specified through the console
menu to open the web interface for system configuration.
The following sections provide instructions about how to make various
connections.
13
Advertisement
Table of Contents
