Changing The Input Display - Onkyo CR-315 Instruction Manual

CR515,315_En.book Page 29 Wednesday, June 7, 2006 2:36 PM
Basic Operation —Continued

Changing the Input Display

You can choose what name is displayed when an input source is selected so that it matches the type of component that
you've connected to the MD/TAPE IN, DOCK/CDR IN, or DIGITAL IN. When you connect an Onkyo
component, it's important that you select the input source name that matches the type of component for
properly.
MENU/NO/
CLEAR
/
1 Use the INPUT [
to select the input source whose
name you want to change.
CR-515 : TAPE, DOCK, DIGITAL*
(*Asian model only)
CR-315 : TAPE
2
Press and hold the
[MENU/NO/CLEAR] button until
"Name Select?" flashes on the
display, and then press [ENTER].
3 Use the Previous or Next
[ ]/[
new input source name.
INPUT
/
YES/MODE
ENTER
]/[ ] buttons
] button to select the
Depending on the input source selected
in step 1, the input source names are
selected in the following orders:
TAPE
DOCK
DIGITAL
GAME/dig
4 Press [ENTER] to confirm your
selection.
"Complete" appears on the display.
On the CR-515, you can also use the front panel con-
trols.
1 Use the [INPUT] button to select the input source
whose name you want to change.
2 Push the multi control to select "Name Select?," and
then push it again.
3 Turn the multi control to select the new input source
name.
4 Push the multi control to confirm your selection.
Input Source Name Abbreviations
Sometimes the input source name may be displayed as a
2-letter abbreviation, as per the following table.
Full name
CDR
DAT
DIGITAL
GAME
DOCK
LINE
LINE1
LINE2
MD
PC
TAPE
VIDEO
-capable
to work
MD VIDEO
DAT
CD-R
PC
CD-R/dig
PC/dig
Abbreviation
CR
DT
DG
GM
DC
LI
L1
L2
MD
PC
TP
VD
29