After carefully unpacking your Burson Soloist 3X GT, inspect for any shipping damage and call your dealer immediately if any is found. Do not plug your Burson Soloist 3X GT into any outlet if you find shipping damage. Please save all packing materials so the unit can be easily and safely shipped if the need arises.
Basic Setup XLR to RCA Output: To achieve an ideal sonic GT, the XLR outputs of the Soloist 3X GT are direct coupling. ie. It has no coupling capacitors or transformers in the audio signal path. However, direct coupling outputs are NOT compatible with off-the-shelf XLR to RCA adaptors like the ones showing below.
Page 4
Therefore, please only use the custom made, Burson marked XLR-RCA adapter we have provided in our accessories box to connect the XLR outputs of our products to any downstream amplifiers with RCA inputs.
Never connect or disconnect the RCA or XLR output cables from the Soloist 3X GT while music is playing. This could damage the Soloist 3X GT. Please stop the music source before disconnecting.
Page 7
The opamp power supply voltage in the Burson Soloist 3X GT is +/-15V. Always remove the power supply before opening up the unit. There are 6 dual opamps inside the Soloist 3X GT. Please refer to the following diagram for the position and correct orientation of the opamps.
The Initial Powering up Make sure volume control has been turned to minimal when using your Soloist 3X GT for the first time. Always power on your source machine first and your power amp last. When powering down your system reverse these steps.
Burson Soloist3. Burson will not pay for loss of use or inconvenience caused by the failure of a Burson Soloist3. Burson will not pay for damage caused to other audio components caused by the failure of the Burson Soloist 3 within the limits allowed by Australian Law.
Need help?
Do you have a question about the Soloist 3X GT and is the answer not in the manual?
Questions and answers