Table of Contents
Advertisement
Device Card and Adjustments
The Device Card can be accessed in the Menu page once you've connected your Spark Amp. Once it's
connected, several settings can be adjusted and statuses can be observed.
1. Tone Control and Bluetooth Audio - Shows the status of your Bluetooth connections between your
device to the Spark Amp
2. EQ Scenario - Change the EQ of your amp's output between Balanced, Rock, Acoustic, Bass to optimize
both music playback and instrument output to your desired mode.
3. HP/Line Out - Adjust this to change the behavior of the Headphone out port. You may select between
the following options:
Stereo
This is the default option. This allows you to connect stereo output sources such as headphones and studio
monitors.
Mono
This option allows you to connect to mono output sources such as guitar amps, powered cabinets, audio
interfaces and other devices with mono inputs.
4. Power Settings - Power Settings will allow you to adjust Spark GO's Auto Standby and Auto Shutdown
features to save battery life.
Spark GO will automatically enter a low power state after a set amount of time has passed where no audio
is detected to preserve battery life. The time it takes to enter standby mode can be adjusted in this menu.
While the Spark GO is in this state, instrument output and music playback will be temporarily disabled. To
enable audio output again, play your plugged in instrument or start audio playback to reactivate it.
5. Voice Guide - Switch the voice guide on/off.
6. Hi-Z Mode - Turn on or off to compensate for different pickup outputs, turn on for high output pickups,
off for low output pickups.
8. Battery - Displays the battery status of your device.
9. Name - Change the display name of your Spark amp when connecting to your Spark.
10. Model - Displays the model of your Spark amp.
11. Firmware - Displays the firmware version installed on your Spark amp.
12. Serial Number - Displays the Serial Number of your Spark amp.
13. Restore to Factory Settings - Restores all settings to the factory defaults.
14. Forget This Device - Remove this device from your list of connected devices.
28
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Spark GO and is the answer not in the manual?
Questions and answers
Как использовать spark go в качестве интерфейса
To use the Positive Grid Spark GO as an audio interface, follow these steps:
1. Connect via USB-C: Use a USB-C to USB-A or USB-C to USB-C cable, depending on your device.
2. Turn on Spark GO: Press and hold the Power/Pair button to turn it on.
3. Connect to a Computer or Device: Plug the USB cable from the Spark GO into your computer, iOS device, or any compatible device with a USB port.
4. Select as Audio Interface: In your recording or effects software (such as Bias FX2), set Spark GO as the input and output audio device.
5. Play and Record: Ensure your instrument is connected to the Spark GO and test the sound.
This setup allows the Spark GO to function as an audio interface for playing and recording guitar.
This answer is automatically generated