JVC HR-J648EH Instructions Manual page 37

Perform steps 1 and 2 of "Storing Channels Manually" on
page 36 to access the Confirmation screen before continuing.
Set Sta tions (A)
SELECT ITEM
1 Press PU SH JO G %fi
blinking. Then press O K twice and the station's name
(ID) begins blinking.
SELECT N EW ST ATIO N
2 Press PU SH JO G %fi until the new station's name (ID)
you want to store begins blinking.
Registered station names (
press PU SH JO G % fi .
SW ITCH ST ATIO N S
Press O K .
3
● Repeat steps
CLO SE CO N FIRMATIO N
SCREEN
Press M EN U .
4
Set Sta tions (B)
N O TE:
First perform step 1 of the above procedure.
SELECT ST ATIO N N AME
CHARACTER
2 Press PU SH JO G
name begins blinking.
EN TER N EW CHARACTER
3 Press PU SH JO G % fi to cycle through the characters
(A–Z, 0–9, –,
desired one is indicated, then press PU SH JO G
enter. Enter the remaining characters the same way
(maximum of 4).
After entering all characters, press O K .
● Repeat steps
● If you make a mistake, press
incorrect character begins blinking. Then enter the
correct character by pressing PU SH JO G % fi .
CLO SE CO N FIRMATIO N
SCREEN
Press M EN U .
4
Downloaded from: https://www.usersmanualguide.com/
until the item you want begins
pg. 38) appear as you
1 through 3 as necessary.
and the first letter of the station
*
, +, (space)) and stop when the
1 through 3 as necessary.
PU SH JO G
Fine-Tuning Cha nnels
Alrea dy Stored
SELECT CHAN N EL TO
FIN E-TUN E
Press PU SH JO G % fi
1
tune begins blinking.
ACCESS MAN UAL CH. SET
SCREEN
Press O K three times. The Manual Ch. Set screen
2
appears.
PERFO RM TUN IN G
Press PU SH JO G % fi until the picture is its clearest.
3
Then press O K .
● The Confirmation screen appears.
● Repeat steps
CLO SE CO N FIRMATIO N
SCREEN
4 Press M EN U .
to
until the
EN
until the channel you want to
1 through 3 as necessary.
37