Table of Contents
Advertisement
4-5 Connection of Cooling Fan power lines
SUMO 4192 / SUMO 4198 / SUMO 5115 has one 12cm silent blue LED cooling fan at the
front, and two at the rear.
There is a cable to connect three fans into one 3-pin connector, place the 3-pin
connector into the fan power connector of the motherboard.
4-6 Installation of 5.25" Front Drive Bay
4-6-1 Open the front panel door and
side panel, remove the plastic
bezel and aluminum EMI plate
through internal of the chassis.
4-6-2 Slide-in the 5.25" device through
the front panel to inline with front
panel bezels.
4-6-3 Secure the 5.25" device with the
internal latch. Refer to the figure
for installation procedure.
4-6-4 Installation completed
4-7 Installation of 3.5" Front Device Bay
The Installation of the 3.5" front device is the same as the installation of the 5.25" front
devices. Please refer to step 4-6.
Required parts: none
4-8 Installation of 3.5" Internal Device Bay
SUMO 4192 / SUMO 4198 / SUMO 5115 provides built-in bays to accommodate up to 5
hard disc drives (after removal of the tool enclosure). The HDD requires securing
runners, which can be found in the tool enclosure.
4-8-1 Place the runners on both sides of
the HDD. Slide the HDD into the
hard disk bay evenly.
4-8-2 For installation of the fourth and
fifth HDDs, loosen the tool
enclosure, and then install the
HDD in accordance with step
4-8-1.
4-8-3 In case the length of power cable is not sufficient for
installation of the bottom HDD, it is possible to use the
power extension cable (4-pin / SATA) inside the tool
enclosure.
4-6-1
4-6-2
4-6-3
4-6-4
LOCK
4-8-1
4-8-2
4-8-3
11
English
Advertisement
Table of Contents
