I-View EPOC-131VA Installation Manual

Ethernet/PoE Extender over 2-Wire Installation Guide
 Product Overview:
1.) Data: BNC Female Connector (No analog video) converter allows 10/100 Base-T Ethernet and PoE power to
be transmitted using coaxial cable or 2-Wire cable such as UTP, STP, 18/2, or similar cable.
2.) Link: The LED indicates the cable link status. The LED will be on after 10 seconds when first connection is
success; Off: No connection.
3.) Pwr: The LED indicates the power status. On: Power on; Off: No power.
4.) Ethernet/PoE: RJ45 connector, attaches to POE IP Camera or Hub via Cat5, 5e, 6 or 7 patch cables.
5.) Eth: The LED indicates the communication status. Flash: Communicate with Traffic; Off: No connection.
6.) Power jack: Plug DC power adapter to for PoE source when PoE Hub cannot provide enough power source.
7.) PoE: The LED indicates the PoE power status. On: PoE power is provided; Off: No PoE power.
1
 Packing Checklist:
Check the package box the following items are included: EPOC-131VA and EOPC-131PS x 1 set; Menu x 1 Pc.
 Installation Steps:
IP camera end
1. Connect the IP camera RJ45 connector to the 10/100BaseT Ethernet port of EPOC-131PS using a standard
Cat5/6 cable of maximum 100 m (328 feet) in length.
2. Connect one end of the long coax cable or 2-Wire cable such as UTP, STP, 18/2 or similar cable to the BNC
connector of EPOC-131PS. (*)(**)
3. When the IP camera and EPOC-131PS cannot receive power through the coax or 2-Wire cable, even through
using the POE+ Hub or plug DC56V power adapter for EPOC-131VA. Plug the DC48V power adapter into the
EPOC-131PS will be needed at this end. Please refer to "Power Distance VS. Cable Impedance" table.
Switch Hub end
1. Connect the PoE switch Hub RJ45 connector to the 10/100BaseT Ethernet port of EPOC-131VA using a standard
Cat5/6 cable of maximum 100 m (328 feet) in length.
2. Connect one end of the long coax cable or 2-Wire cable such as UTP, STP, 18/2 or similar cable to the BNC
connector of EPOC-131VA. (*)(**)
3. When the IP camera and EPOC-131PS cannot receive power through the coax or 2-Wire cable, please change the
POE+ Hub or plug DC56V power adapter to EPOC-131VA.
* Using 2-Wire cable should plug BTB-100 BNC to Terminal block converter. Connect the converter
to the BNC jack on the EPOC-131PS and connect one wire conductor to a terminal marked "+".
Connect the other wire conductor to a terminal marked "-". Observe polarity so that it will match that
2 3 4 5
1
6
1
1 7 2 5
3 4
V1.2
6