Panasonic AG-VF5P Service Manual page 49

3. Remove Lens Holder and Plate Spring from
Eyepiece Holder.
Note: When installing, set Plate Spring into groove of
Eyepiece Holder as shown in the figure, and
then install Lens Holder Ring by setting its
bosses (2 place) into groove of Eyepiece Holder.
4. Along groove of Lens Holder, slide Lens Holder
Ring clockwise and remove it.
Note: When installing, make sure that bosses of Lens
Holder Ring are in the side of the Lens Holder as
shown in the figure. After confirmation, install the
Lens Holder Ring by setting its bosses into
groove of Lens Holder.
5. Removal of Top Case
1. Loosen 4 screws (D), and then remove Top Case.
6. Removal of the CRT Ass'y
1. Pull out connectors (2 for the portion a,b each) on
C.B.A. and CRT socket (portion C)
2. Remove Slip Ring and Packing from CRT case.
Note: When install Slip Ring, put the projection of A
portion into groove until it clicks.
DIS - 2