Table of Contents
Advertisement
Proceed with positioning on the pump.
•
Glue two strips of Velcro A, one on the pump B
and the other on the power supply C, and then
fasten the two devices together.
B
C
A
Fastening on the pump
TROUBLESHOOTING
SYMPTOM
1)
With the switch in ON position,
no LED are ON.
2)
With the switch in ON position,
the LED L1 is blinking and L2
is OFF.
•
•
Ion
iPump
Meaning of the "WEEE" logo found in labels.
The following symbol is applied in accordance with the
EC WEEE (Waste Electrical and Electronic Equipment)
Directive.
This symbol (valid only in countries of the European
Community) indicates that the product it applies to
must NOT be disposed of together with ordinary
domestic or industrial waste but must be sent to a
differentiated waste collection system.
The end user is therefore invited to contact the supplier
of the device, whether the Parent Company or a
retailer, to initiate the collection and disposal process
after checking the contractual terms and conditions of
sale.
POSSIBLE CAUSE
- The battery is exhausted.
- The current that supplies the pump
is < 50 nA. Discharge is not
activated and the pump does not
work.
16/16
TECHNICAL INFORMATION
Make the electric connection between the power
supply and pump.
Turn switch D to ON.
DISPOSAL
- Change the battery.
- Increase the pressure inside the
pump (ex. by heating the pump),
discharge is activated and L1 goes
OFF and L2 starts blinking.
D
FIXING
87-900-111-01 (C)
Advertisement
Table of Contents
