Table of Contents
Advertisement
The overall dimensions of the power supply are shown
in the figure below.
Dimensions in mm [inches]
INSTALLATION
The various components of the Ion Pump HV P.S. kit
are shown in the figure below:
2
Ion Pump HV P.S. Kit
1. Ion Pump HV P.S.
2. Strip of Velcro to fasten the Ion Pump P.S. to the
pump body
The device is dispatched with the battery inserted in its
housing but with the contacts isolated by a strip of
insulating Mylar.
To establish contact between the terminals of the
battery and the circuit of the device, proceed as follows:
1
•
Check that the ON/OFF switch is set to OFF.
•
Back off the 4 screws A.
•
Open the cover of the unit.
•
Remove the strip of Mylar inserted between the
terminals of the battery C and the contacts of the
battery-holder.
•
Replace the cover of the unit and re-insert the four
screws A.
15/16
TECHNICAL INFORMATION
B
Positioning of the battery
A
C
87-900-111-01 (C)
Advertisement
Table of Contents
