Table of Contents
Advertisement
OFA 8L with Learning Owners Manual.fm Page 17 Monday, January 24, 2005 10:04 AM
TROUBLESHOOTING
PROBLEM:
LED (red light) does not
blink when you press a
key.
SOLUTION:
Replace batteries with two
new AAA alkaline
batteries.
PROBLEM:
LED (red light) blinks five
times after you press a key.
SOLUTION:
Replace batteries with two
new AAA alkaline
batteries.
PROBLEM:
LED blinks when you
press a key, but home
entertainment device does
not respond.
SOLUTION:
Make sure the remote
control is aimed at your
home entertainment
device and is not farther
than 15 feet away.
PROBLEM:
The unit does not control
home entertainment
devices or commands are
not working properly.
SOLUTION:
Try all listed codes for the
device brands being set
up. Make sure they can be
operated with an infrared
remote control.
PROBLEM:
TV/VCR Combo does not
respond properly.
SOLUTION:
Use the VCR codes for your
brand. Some combo units
may require both a TV code
and a VCR code for full
operation.
O
WNER
PROBLEM:
Changing channels does
not work properly.
SOLUTION:
If the original remote
control required pressing
ENTER to change channels,
then press ENTER on the
remote control after
entering the channel
number.
PROBLEM:
During learning, LED
emits a long blink after
pressing and holding key
to be learned.
SOLUTION:
Memory is full or a bad
capture has occurred.
Avoid high-ambient light
sources, such as direct
daylight and fluorescent
bulbs. Try readjusting
positions of remote
controls before performing
the procedure again.
PROBLEM:
Tried Searching For Your
Code method and still
could not find a working
code.
SOLUTION:
Clear the device key as
follows: Press and hold SET
until the LED (red light)
blinks twice, then
release.Next enter 9 9 2.
Then press the device key
to be cleared twice.Now
repeat the Searching for
Your Code method on page
8.
PROBLEM:
CH+ and CH- do not work
for your RCA TV.
Troubleshooting 17
'
M
S
ANUAL
Hide quick links:
Advertisement
Table of Contents
