Advertisement
WARNING: DISCONNECT MACHINE FROM THE
POWER SOURCE AND REMOVE BLADE GUARD
BEFORE USING THE TENONING JIG. REINSTALL
THE
BLADE
GUARD
TENONING JIG USE IS COMPLETE. ALWAYS
UNPLUG THE TABLESAW BEFORE REMOVING OR
INSTALLING THE BLADE GUARD. FAILURE TO
COMPLY MAY CAUSE SERIOUS INJURY.
1. Fasten vertical work support assembly (A) Fig 2, to
tenoning jig base (B) with two special shoulder bolts (C),
and place the M6.4 Flat washer onto knob (D) and fasten
to jig base (B).
2. Fasten clamp arm (A) Fig. 3, to the back of the work
support plate using two M10x1.5x20mm socket head
screws (B), and two M10 lockwashers as shown.
3. Fasten clamp assembly (C) Fig. 4, to clamp arm (A)
using the clamp handle with stud (D) as shown.
4. Fasten handles (F) Fig. 4, to the base (H) as shown.
5. IMPORTANT: The guide bar (G) Fig. 4, located on
the base (H) of the tenoning jig, has been preset at
the factory for operation on right tilting arbor saws.
If you are using the tenoning jig on a right tilting
arbor saw, proceed with instructions for "ALIGNING
TENONING JIG". If you are using the tenoning jig on
a left tilting arbor saw, the guide bar (G) Fig. 4, must
be relocated on the base (H) of the tenoning jig, as
follows:
FOR LEFT TILTING ARBOR SAWS ONLY
NOTE: PLACE THE TENONING JIG IN THE MITER
GAUGE SLOT TO THE LEFT OF THE BLADE.
6. Using a 3mm allen wrench, loosen set screw (M)
Fig. 6, while pushing in on thread release button (P),
remove micro-adjustment assembly (N) from tenoning
jig as shown in Fig. 7.
7. Loosen and remove lock handle (K) and flat washer
Fig. 5, from tenoning jig.
ASSEMBLY
IMMEDIATELY
AFTER
K
Fig. 5
C
B
A
D
C
4
A
D
Fig. 2
B
A
Fig. 3
Fig. 4
P
N
Fig. 6
C
F
H
G
M
Advertisement
