ProBreeze PB-AC07-US Instruction Manual page 6

2.
Water Tank
• Before adding water always unplug the
device.
• Rotate the clip on the outside of the unit
to free the water tank.
• With two hands, gently remove the water
tank halfway.
• Gently press the fixing clips to loosen and
remove the pump. This will allow you to
fully remove the water tank.
• Add clean tap water to the tank. Note:
the water level is visible from the outside
of the water tank. Do not fill above the
MAX line or allow your device to run
below the MIN line as this can damage
your product.
• Gently press the fixing clips to secure the
pump in place before slowly pushing the
water tank back into the unit.
• Fasten the tank in place by rotating the
locking clip.
NOTE: to reduce the temperature of the air
generated by your air cooler, add the ice
packs provided and/or cooled water to the
tank.
10 of 48 | English
1.
Fixing
Clip
Water
Level
Control Panel
1. Oscillation
2. Activate Humidification Mode
3. Change Mode
4. Timer Mode
5. Change Speed
6. On/Off
1
Remote Control
• The remote control requires 2 x AAA size batteries.
• The remote control can be used from 4 meters away from the device.
• The remote control operations are similar to the control panel. Please see the "using your
product" section for more details.
1. Turn the device on or off
2. Switch mode / function (fan speed, timer
function, humidification mode, change mode)
3. Set requirements in selected mode (e.g. fan
speed when in FAN mode, time when in TIMER
mode)
4. Start / stop oscillation
2 3 4 5 6
4
2
1
1
2
3
4
English | 11 of 48