Using The Mug Press; Instructions - Technotape HPM.MUG.350.005 User Manual

USING THE MUG PRESS

INSTRUCTIONS

Ceramic mug-like products (from 10oz mugs up to
beer mugs)
Before you switch on the mug press, set the correct
diameter of the mug press by adjusting the central screw
(Picture C). The 'correct diameter' means that you can close
the press with light pressure.
For temperature and time settings, check the time
and temperature overview at www.technotape.com >
Downloads > Time & Temperature.
Place the sublimation paper with the printed side of the
sublimation paper towards the product and adjust it with
special Technotape Heat Transfer Tape.
When the press has reached the set-temperature, you can
place the product into the press.
Close the press and push the start / stop button button.
It will take some time for the press to reach the highest-
temperature. Once it has been reached, the sublimation
process begins, and the press will count down the set time
automatically.
Once the sublimation time has finished, the press will make
a long beeping sound. Open the press and press the start
button to stop the sound.
Remove the tape and sublimation paper directly after the
job has finished. But be careful because the mug is very hot.
PICTURE C
4
PRODUCTION TIP!
For the best and sharpest result, dip
the mug into cold water immediately.