Control Unit Settings; System Instructions - Technotape HPM.MUG.350.005 User Manual

CONTROL UNIT SETTINGS

SYSTEM INSTRUCTIONS

Connect the power cord.
Switch the press on.
All read-outs are in Celsius. For Fahrenheit see the table on
page 7.
To set the set-temperature (Picture A), press the mode
button once. Then, adjust it with the plus and minus button.
The maximum set-temperature is 180°C.
To set the highest-temperature, press the mode button
for the second time. Then, adjust it with the plus and
minus button. Usually, this is a few degrees above the set-
temperature. The maximum highest-temperature is 200°C.
To set the sublimation time, press the mode button for the
third time. Then, adjust it with the plus and minus button.
To confirm the temperatures and time, press the mode
button for the fourth time.
The press will automatically heat up to the set-temperature.
When it has reached this temperature, the press will make
a beeping sound.
To start the sublimation process, press the start / stop
button once. First, the press will heat up to the highest-
temperature. When this has been reached, the press will
count down the set time.
When the press has counted down to zero and the process
has finished, the press will make a long beeping sound.
Press the start / stop button again and it will stop.
To unplug a press accessory, make sure the power is
switched off and the press is cooled down. Press the safety
catch on the right side of the plug to release it (Picture B).
NOTE!
The set-temperature is always lower
than the highest-temperature. If you
want to increase the set-temperature,
you need to increase the highest-
temperature first.
PICTURE A
Minus button
Mode button
Plus button
Start / stop button
Highest-temperature light
Set-temperature light
Sublimation time light
PICTURE B
Safety catch
3