Garmin GPS 400 Pilot's Manual & Reference page 84

SECTION 5
PROCEDURES
11) After crossing the FAF, the destination
sequences to the MAP ('RW03', the runway
threshold, see Figure 5-19). Fly toward the
MAP.
Figure 5-19 Sequence to MAP
NOTe: When viewing the Map Page, note that
the final course segment is displayed in magenta
(the active leg of the flight plan always appears
in magenta) and a dashed line extends the course
beyond the MaP. The dashed line is provided for
situational awareness only and should NOT be
used for navigation. Follow the published missed
approach procedures.
12) When approaching the MAP, a waypoint alert
('APPRCHING WPT') appears in the lower right
corner.
13) After crossing the MAP, 'SUSP' appears above
the OBS Key (Figure 5-20), indicating that
automatic sequencing of approach waypoints
is suspended at the MAP. A 'from' indication
is displayed on the CDI and Default NAV Page,
but course guidance along the final approach
course continues. If a missed approach is
required, use the OBS Key to initiate the missed
approach sequence, as outlined, beginning on
the following page.
5-8
Flying the Missed Approach
After passing the MAP, if the runway is not in sight
the pilot must execute a missed approach. The GPS 400
continues to give guidance along an extension of the final
course segment (FAF to MAP) until the pilot manually
initiates the missed approach procedure (as mentioned
previously in reference to the 'SUSP' advisory).
GPS 400 Pilot's Guide and Reference
Figure 5-20 'SUSP' Annunciation


DO NOT USE FOR
NAVIGATION
Figure 5-21 Sequence to MAP
190-00140-60 Rev. H

