Table of Contents
Advertisement
B070A01A-AAT
THEFT-ALARM SYSTEM (If installed)
This system is designed to provide protection
from unauthorized entry into the car. This sys-
tem is operated in three stages: the first is the
"Armed" stage, the second is the "Alarm" stage,
and the third is the "Disarmed" stage. If trig-
gered, the system provides an audible alarm
with blinking of the turn signal lamp.
B070B01A-GAT
Armed Stage
Park the car and stop the engine. Arm the
system as described below.
1) Remove the ignition key from the ignition
switch.
2) Make sure that the engine hood and trunk lid
are locked.
3) Lock the doors using the transmitter of the
keyless entry system.
After completion of the steps above, the turn
signal lamp will blink once to indicate that the
system is armed.
NOTE:
1) If any door, trunk lid or engine hood
remains open, the system will not be
armed.
2) If this happens, rearm the system as
described above.
CAUTION:
Do not arm the system until all passengers
FEATURES OF YOUR HYUNDAI
have left the car. If the system is armed
while a passenger(s) remains in the car, the
alarm may be activated when the remaining
passenger(s) leaves the car.
B070C02A-AAT
Alarm Stage
The alarm will be activated if any of the follow-
ing occurs while the car is parked and the
system is armed.
1) A front or rear door is opened without using
the transmitter or the ignition key.
2) The trunk lid is opened without using the
ignition key.
3) The engine hood is opened.
The siren will sound and the turn signal lamp
will blink continuously for 30 seconds (It hap-
pens 3 times). To turn off the system, unlock
the door with the transmitter or the ignition key.
CAUTION:
Avoid trying to start the engine while the
system is armed.
B070D01A-GAT
Disarmed Stage
UNLOCK
LOCK
YR10181A
The system will be disarmed when the following
step is taken:
The driver's or passenger's door is unlocked by
depressing the "UNLOCK" button on the trans-
mitter or the ignition key.
After completion of the steps above, the turn
signal lamp will blink twice to indicate that the
system is disarmed.
NOTE:
Once the system has been disarmed, it can
not be rearmed except by repeating the
arming procedures.
PANIC
B070D01L
1- 3
Hide quick links:
Advertisement
Table of Contents
